This is a great way to add some lethality to a close-quarter weapon that may give you a small advantage during reloading, but more importantly, looks cool. Good value for the price. I wish the paint finish was a little better done, but it's even and looks good where it shows.

ALL GOOD

This is great but when is one coming out for the T300 A1 ???

Excellent, easy to install. Holds a M7 or M9 Bayonet with no issues. Just make sure to order a extension with it. I ordered the +1 extension.

Lug fit nice and snugly on the tube extension. The hex screw is a little bit of a concern but so far has held on well enough when shooting. But it worked a treat in mount a mark 7 bayonet from Smith & Wesson on the shotgun

The rear mount is well made and solid secured with two set screws however the front adapter though well made only has one tiny set screw that will easily strip if not careful a larger diameter set would have been better.

As stated in a previous review the product is great as far as finish haven't loaded rounds or taken to the range yet but the fit is a bit off on the thread depth approximately a 1/16" and it won't thread tight enough to engage the locking ball bearing. It's a minor issue but still an issue that hopefully will be addressed, "lock-tight" doesn't feel right for me might have to do a little filing otherwise still happy.

A bayonet on a shotgun.. why not! Nice product. Seems well made. I'm a little concerned on the set screw feeling a bit weak, but it looks great.

The product overall is well built. The only weak part of the product is the very small Allen screw that holds one part on to the EXT +1 tube. It's super small and I doubt it will hold up to 12ga recoil. Also the actual lug for the bayonet is super tight when affixing an actual M7 bayonet made by Ontario knife. Perhaps the cheap knock off ones go on easier, but I found it difficult to get the bayonet to seat properly and reliably without having to play around with it. It should be a quick snap on and go operation.