Tokarev Titan/Hammer 12G Heat Shield, Black

Easy to install, but after installation the barrel does not sit perfectly back to its original position by about almost 1/4”. I Haven’t shot it yet, but I’ll I’m not sure how I like not being able to fully tighten down the magazine cap to its previous position.

Good Quality, only issue was I had to file down the notch at the top so it fit correctly on the barrel

Requires fitting. Better have a file handy.

These are great. Don't listen to the reviews below. These shields fit great. Take the barrel out about 1.5 inches. The front of the shield will slide over the front sight. If it is stiff, wiggle it side to side until it fully slides up under the notch built into the sight. You will know you have it right when the rear of the shield is flush with the recess in the rear of the barrel. You could hit it with a file for easier installation, but you will not have the same lockup when it is finally installed.

Prefect fit! I seen alot of people saying they had to file it down to fit, take your barrel loose and side it out a inch and everything falls right in place! Love the aggressive look it gave it to!

Had to file 1/16 inch from sight notch to make it fit. It only took 30 seconds.worked perfectly afterwards.

Not sure if I’m missing something but I’ve installed heat shields on my shotguns before and they are pretty straight forward. This heat shield appears to be cut just slightly too long for my Titan.

Nice fit and good quality.

Looks nice. Needs a better way to secure to barrel. Overall, adds a nice touch to my shotgun.